Go to TOP

Holybro Kakute F7 AIO V1.5 Flight Controller OSD PDB+Atlatl HV V2 5.8G FPV Transmitter for RC Drone Kakute F7

Product code: PTO_0B78EFAJ

$94.73 $112.80 

SOLD OUT
Quantity:
Holybro Kakute F7 AIO V1.5 Flight Controller OSD PDB+Atlatl HV V2 5.8G FPV Transmitter for RC Drone Kakute F7
Ship to: FREE SHIPPING to United States via YUNTU--Special Priority Line Registration  
Supplier:JYL_SHOP
Rank:4.4
Buy More... Get Lower PricesYes! We Ship To  us

Payment Guarantee:smile
Shipping Support:smile
Share To:
.
Holybro Kakute F7 AIO V1.5 Flight Controller OSD PDB+Atlatl HV V2 5.8G FPV Transmitter for RC Drone Kakute F7
Holybro Kakute F7 AIO V1.5 Flight Controller OSD PDB+Atlatl HV V2 5.8G FPV Transmitter for RC Drone Kakute F7
$94.73 
.

Supports Beta-flight, Butter-flight, and Clean-flight.

High-performance / low-noise / high sensitivity IMU. MPU6000 with 6-axis gyro and

accelerometer.

Supports BLHeli pass-through for easy ESC upgrade and configuration.

Compatible with all major FPV receivers from vendors such as Fatshark, ImmersionRC, etc.

Supports the standard 40-channel set: band A, B, E, Fatshark, and Raceband.

SmartAudio input allows remote control by the flight controller.

LED indicators for channel, band, and power.

.

Specification:
Kakute F7 flight controller:
Click For Kakute F7 AIO V1.5 Manual
•MCU: STM32F745 32-bit processor
IMU: MPU6000 (SPI)
Barometer: BMP280
Current Sensor: Approximately 130 amps maximum measurable value
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
6 hardware UARTS (UART1,2,3,4,6,7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on
any UART without "uninvert hack".
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not
supported.
TF card for Blackbox logging
Dimensions: approx. 35x41x7mm (includes foam-mounted gyro board in height)
Mounting Holes: Standard 30.5mm square to center of holes
Weight: approx. 8g

Atlatl HV V2:
Click For Atlatl HV V2 Manual
Output Power: 0.5 mW (pit mode), 25 mW, 200 mW, 500 mW, 800 mW
Audio: 6.5 MHz Mono
Antenna Connector: MMCX
Input Voltage: 7 to 28 volts (2-6S LiPo) with absolute maximum 42 volts
Dimensions: approx. 35x25x7mm (Includes USB height)
Mounting Holes: Standard 30.5mm square to center of holes
Weight: approx. 9.3g

Packing list:
1 x Kakute f7 AIO V1.5 +Atlatl V2 stack
1 x 80mm SMA--MMCX Cable
1 x 150mm 4pin JST GH wire

.
Date Launched: Jun 02 2020
Previous     Next
All categories 