Go to TOP

Holybro Kakute F7 Flight Controller Atlalt HV V2 25~800mW VTX Tekko32 F3 40A Blheli_32 Brushless ESC Stack 30.5x30.5mm as shown

Product code: PTO_077O040C

$128.02 $152.61 

SOLD OUT
Quantity:
Holybro Kakute F7 Flight Controller Atlalt HV V2 25~800mW VTX Tekko32 F3 40A Blheli_32 Brushless ESC Stack 30.5x30.5mm as shown
Ship to: FREE SHIPPING to United States via YUNTU--Special Priority Line Registration  
Supplier:XFM STATION
Rank:5
Buy More... Get Lower PricesYes! We Ship To  us

Payment Guarantee:smile
Shipping Support:smile
Share To:
.
Holybro Kakute F7 Flight Controller Atlalt HV V2 25~800mW VTX Tekko32 F3 40A Blheli_32 Brushless ESC Stack 30.5x30.5mm as shown
Holybro Kakute F7 Flight Controller Atlalt HV V2 25~800mW VTX Tekko32 F3 40A Blheli_32 Brushless ESC Stack 30.5x30.5mm as shown
$128.02 
.

--Soft-mounting built in. The IMU ("gy ro") chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.

--High-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gy ro and accelerometer. Can run at up to 32 kHz sampling rate.

--Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with external GPS/magnetometer units.

--2 oz. copper PCB allows up to 120A maximum continuous current.

.

Description:

Product categories: Flight Controller

Kakute F7:

MCU: STM32F745 32-bit processor

IMU: ICM20689 (SPI)

Barometer: BMP 280

Current Sensor: Approximate 130 amps maximum measurable value

USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)

6 hardware UARTS (UART1, 2, 3, 4, 6, 7)

All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without "uninvert hack".

Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.

TF card for Blackbox logging

Dimensions: 35x41x7mm (including foam-mounted Gy ro board in height)

Mounting Holes: Standard 30.5 mm square to center of holes

Weight: 9g

Tekko32 F3 4in1 40A ESC:

32bit ESC with BLHELI32 firmware

Supports 3-6S lipo input

PWM input, TLM support

Voltage output (VBAT)

NO BEC

Supports oneshot/Multishot/Dshot PWM

Mounting holes 30.5x30.5mm

Supports damped light

Weight: 11.6g

Atlatl VTX:

Output Power: 0.5 mW (pit mode), 25 mW, 200 mW, 500 mW, 800 mW

Audio: 6.5 MHz Mono

Antenna Connector: MMCX

Input Voltage: 7 to 28 volts (2-6S LiPo) with absolute maximum 42 Volts

Dimensions: 35x25x7mm (Includes USB height)

Mounting Holes: Standard 30.5 mm square to center of holes

Weight: 9.3g

Packages:

1 x Kakute F7 +Atlatl HV V2 stack

1 x Tekko32 F3 4in140A ESC

1 x Tekko32 F3 4in1 40A ESC

1 x Electrolytic capacito: 1000uF 35v

1 x 8pin to 8pin 1mm pitch 65mm cable

1 x 8pin to 8pin 1mm pitch 25mm cable

Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.

.

Customer Reviews(0)

5 out of 5
5 star rating 5 star rating 5 star rating 5 star rating 5 star rating
Holybro Kakute F7 Flight Controller Atlalt HV V2 25~800mW VTX Tekko32 F3 40A Blheli_32 Brushless ESC Stack 30.5x30.5mm as shown
Deliverystarrs 5starrs 5starrs 5starrs 5starrs 5
Value for Moneystarrs 5starrs 5starrs 5starrs 5starrs 5
Packagingstarrs 5starrs 5starrs 5starrs 5starrs 5
Ease of Setup/Usestarrs 5starrs 5starrs 5starrs 5starrs 5
Function/Performancestarrs 5starrs 5starrs 5starrs 5starrs 5
Write Review
Date Launched: Jun 02 2020
Previous     Next
All categories 